Step By Step Roofing Installation

Seal the top nail holes and continue on up with your shingles.

Step by step roofing installation.

This aluminum flashing protects the edges of the roof sheathing from water. Ice and water shield sticks to the wood decking which prevents any water leaks. Trim the shingles with your utility knife photo 14. Install shingles from the lower left corner working to the right and also working up the roof slope.

Install a drip edge around the perimeter of the roof. Install the roofing screws vertically along each rib in the panel. The washer under the screw head should seal to the surface of the panel without bulging or shifting. Ice and water shield installation next step is installing ice and water shield which is a special type of roofing underlayment.

The type of materials used will greatly affect the method of roof installation. Install the shingles up and halfway past the vent hole or stack. Installing the roof. Measure the roof area.

Add an insulation layer so that it traps moisture between the sheathing and the metal roof. This involves another four steps. The following 8 instruction steps will guide you through the installation of a metal roof. Nail it down with your roofing gun top and bottom.

Use the 1 25 inch nails to secure the metal strips on the flashing. Step by step roll roofing installation. Secure the roofing felt using a staple gun. Prepare a valley between joined roofs by cutting a strip that is 18 inches wide and covers the entire length of.

Install the starter strip which is just a backing for the first visible row of shingles. During a diy roof installation job paying attention to manufacturer s directions is of the utmost importance. The above roof installation steps are intended to give you a basic guideline to install new roofing materials. Getting the right result will help you determine the right amount of metal roofing material you ll need to order.

It must be installed at the bottom of the roof and at all roof penetrations chimneys pipe flanges roof connections etc. You first measure the roof s width and length then add the desired overhang measuring from the lowest. Start by installing the edges. Next install your vent or stack flashing over that row of shingles photo 13.

You will need to order enough metal material to cover the entire roof and this process starts with measuring the full size of your roof in square feet. It stops water from getting through to the roof at. Secure the screws but do not overtighten.